H3C Technologies H3C S6800 Series Switches User Manual

Page 421

408

[NPE1-vsi-aaa-ldp] quit

[NPE1-vsi-aaa] quit

Configure NPE 2:
# Configure basic MPLS.

system-view

[NPE2] interface loopback 0

[NPE2-LoopBack0] ip address 3.3.3.3 32

[NPE2-LoopBack0] quit

[NPE2] mpls lsr-id 3.3.3.3

[NPE2] mpls ldp

[NPE2–ldp] quit

# Enable L2VPN.

[NPE2] l2vpn enable

# Configure VSI aaa that uses LDP as the PW signaling protocol, and establish PWs to UPE, NPE
2, and NPE 3.

[NPE2] vsi aaa

[NPE2-vsi-aaa] pwsignaling ldp

[NPE2-vsi-aaa-ldp] peer 1.1.1.1 pw-id 500 no-split-horizon

[NPE2-vsi-aaa-ldp-1.1.1.1-500] quit

[NPE2-vsi-aaa-ldp] peer 2.2.2.2 pw-id 500

[NPE2-vsi-aaa-ldp-2.2.2.2-500] quit

[NPE2-vsi-aaa-ldp] peer 4.4.4.4 pw-id 500

[NPE2-vsi-aaa-ldp-4.4.4.4-500] quit

[NPE2-vsi-aaa-ldp] quit

[NPE2-vsi-aaa] quit

Configure NPE 3:
# Configure basic MPLS.

system-view

[NPE3] interface loopback 0

[NPE3-LoopBack0] ip address 4.4.4.4 32

[NPE3-LoopBack0] quit

[NPE3] mpls lsr-id 4.4.4.4

[NPE3] mpls ldp

[NPE3–ldp] quit

# Enable L2VPN.

[NPE3] l2vpn enable

# Configure VSI aaa that uses LDP as the PW signaling protocol, and establish PWs to NPE 1 and
NPE 2.

[NPE3] vsi aaa

[NPE3-vsi-aaa] pwsignaling ldp

[NPE3-vsi-aaa-ldp] peer 2.2.2.2 pw-id 500

[NPE3-vsi-aaa-ldp-2.2.2.2-500] quit

[NPE3-vsi-aaa-ldp] peer 3.3.3.3 pw-id 500

[NPE3-vsi-aaa-ldp-3.3.3.3-500] quit

[NPE3-vsi-aaa-ldp] quit

[NPE3-vsi-aaa] quit

# Create VLAN 10 and assign FortyGigE 1/0/1 to the VLAN.

This manual is related to the following products: