H3C Technologies H3C S6800 Series Switches - Manual (Page 265)

252
Figure 69 Network diagram
Table 19 Interface and IP address assignment
Device Interface IP address Device Interface IP address
CE 1 Vlan-int12 10.2.1.1/24 CE 3 Vlan-int12 10.1.1.1/24
CE 2 Vlan-int13 10.4.1.1/24 CE 4 Vlan-int13 10.3.1.1/24
UPE 1 Loop0 1.1.1.9/32 UPE 2 Loop0 4.4.4.9/32
Vlan-int11 172.1.1.1/24 Vlan-int11 172.2.1.1/24
Vlan-int12 10.2.1.2/24 Vlan-int12 10.1.1.2/24
Vlan-int13 10.4.1.2/24 Vlan-int13 10.3.1.2/24
SPE 1 Loop0 2.2.2.9/32 SPE 2 Loop0 3.3.3.9/32
Vlan-int11 172.1.1.2/24 Vlan-int11 172.2.1.2/24
Vlan-int12 180.1.1.1/24 Vlan-int12 180.1.1.2/24
Configuration procedure
1. Configure UPE 1:
# Configure basic MPLS and MPLS LDP to establish LDP LSPs.
system-view
[UPE1] interface loopback 0
[UPE1-LoopBack0] ip address 1.1.1.9 32
[UPE1-LoopBack0] quit
[UPE1] mpls lsr-id 1.1.1.9
[UPE1] mpls ldp
[UPE1-ldp] quit
[UPE1] interface vlan-interface 11
[UPE1-Vlan-interface11] ip address 172.1.1.1 24
[UPE1-Vlan-interface11] mpls enable
[UPE1-Vlan-interface11] mpls ldp enable
[UPE1-Vlan-interface11] quit
# Configure the IGP protocol (OSPF, in this example).
文件中找不到关系 ID 为 rId91 的图像部件。