Ipv6 mce configuration example, Network requirements – H3C Technologies H3C S6800 Series Switches User Manual
Page 481
468
Task Command
Display information about a
specified VPN instance or all VPN
instances.
display ip vpn-instance [ instance-name vpn-instance-name ]
Display BGP peer group information
for a VPN instance.
display bgp group ipv6 [ unicast ] vpn-instance vpn-instance-name
[ group-name group-name ]
Display BGP peer information for a
VPN instance.
display bgp peer ipv6 [ unicast ] vpn-instance vpn-instance-name
[ ipv6-address prefix-length | { ipv6-address | group-name
group-name } log-info | [ [ ipv6-address ] verbose ] [ standby slot
slot-number ] ]
For commands that display information about a routing table, see Layer 3—IP Routing Command
Reference.
For more information about the display bgp group and display bgp peer commands, see Layer 3—IP
Routing Command Reference.
IPv6 MCE configuration example
Network requirements
As shown in
, RIPng runs in VPN 2. Configure the MCE device to separate routes from different
VPNs and advertise VPN routes to PE 1 through OSPFv3.