H3C Technologies H3C S6800 Series Switches - Manual (Page 197)

184
Step Command Remarks
4. Set the maximum
number of active routes
allowed.
routing-table limit number
{ warn-threshold | simply-alert }
By default, the number of active
routes allowed for a VPN instance
is not limited.
Setting the maximum number of
active routes for a VPN instance
can prevent the PE from learning
too many routes.
5. Apply an import routing
policy.
import route-policy route-policy
By default, all routes matching the
import target attribute are
accepted.
The specified routing policy must
have been created.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
6. Apply an export routing
policy.
export route-policy route-policy
By default, routes to be advertised
are not filtered.
The specified routing policy must
have been created.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
7. Apply a tunnel policy to
the VPN instance.
tnl-policy tunnel-policy-name
By default, only one tunnel is
selected (no load balancing) in this
order: LSP tunnel and CR-LSP
tunnel.
The specified tunnel policy must
have been created.
For information about tunnel
policies, see "
Configuring tunnel
policies ."
Configuring routing between a PE and a CE
You can configure static routing, RIP, OSPF, IS-IS, EBGP, or IBGP between a PE and a CE.
Configuring static routing between a PE and a CE
Step Command Remarks
1. Enter system view. system-view N/A