H3C Technologies H3C S6800 Series Switches - Manual (Page 353)

340
[PE2-ospf-1-area-0.0.0.0] network 192.3.3.3 0.0.0.0
[PE2-ospf-1-area-0.0.0.0] quit
[PE2-ospf-1] quit
# Create VLAN 10 and assign FortyGigE 1/0/1 to the VLAN.
[PE2] vlan 10
[PE2-vlan10] port fortygige 1/0/1
[PE2-vlan10] quit
# Create service instance 10 on FortyGigE 1/0/1 to match packets that have an outer VLAN ID
of 10.
[PE2] interface fortygige1/0/1
[PE2-FortyGigE1/0/1] service-instance 10
[PE2-FortyGigE1/0/1-srv10] encapsulation s-vid 10
[PE2-FortyGigE1/0/1-srv10] quit
[PE2-FortyGigE1/0/1] quit
# Create a cross-connect group named vpna, create a cross-connect named svc in the group, and
bind service instance 10 on FortyGigE 1/0/1 to the cross-connect.
[PE2] xconnect-group vpna
[PE2-xcg-vpna] connection svc
[PE2-xcg-vpna-svc] ac interface FortyGigE 1/0/1 service-instance 10
# Create a static PW for the cross-connect to bind the AC to the PW.
[PE2-xcg-vpna-svc] peer 192.2.2.2 pw-id 3 in-label 200 out-label 100
[PE2-xcg-vpna-svc-192.2.2.2-3] quit
[PE2-xcg-vpna-svc] quit
[PE2-xcg-vpna] quit
5. Configure CE 2.
system-view
[CE2] interface fortygige 1/0/1
[CE2-FortyGigE1/0/1] port link-type trunk
[CE2-FortyGigE1/0/1] port trunk permit vlan 10
[CE2-FortyGigE1/0/1] quit
Verifying the configuration
# Display L2VPN PW information on PE 1. The output shows that a static PW has been established.
[PE1] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpna
Peer PW ID In/Out Label Proto Flag Link ID State
192.3.3.3 3 100/200 Static M 0 Up
# Display L2VPN PW information on PE 2. The output shows that a static PW has been established.
[PE2] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: vpna
Peer PW ID In/Out Label Proto Flag Link ID State