Bgp auto-discovery ldp pw configuration example, Network requirements, Configuration procedure – H3C Technologies H3C S6800 Series Switches User Manual
Page 410
397
Remote Label Block : 131224/10/0
Export Route Target: 1:1
BGP auto-discovery LDP PW configuration example
Network requirements
Use BGP to discover remote PEs and use LDP to create PWs among PEs so CEs in different sites of VPN
1 can communicate with each other.
Figure 102 Network diagram
Configuration procedure
1.
Configure the IGP and public tunnels. (Details not shown.)
2.
Configure PE 1:
# Configure basic MPLS.
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 1.1.1.9 32
[PE1-LoopBack0] quit
[PE1] mpls lsr-id 1.1.1.9
[PE1] mpls ldp
[PE1-ldp] quit
# Establish IBGP connections to PE 1 and PE 2, and use BGP to advertise VPLS PE information.
[PE1] bgp 100
[PE1-bgp] peer 2.2.2.9 as-number 100
[PE1-bgp] peer 2.2.2.9 connect-interface loopback 0
[PE1-bgp] peer 3.3.3.9 as-number 100
[PE1-bgp] peer 3.3.3.9 connect-interface loopback 0
[PE1-bgp] address-family l2vpn
[PE1-bgp-l2vpn] peer 2.2.2.9 enable
[PE1-bgp-l2vpn] peer 3.3.3.9 enable
[PE1-bgp-l2vpn] quit
[PE1-bgp] quit
文件中找不到关系
ID 为 rId130 的图像部件。