Configuration restrictions and guidelines, Configuration procedure – H3C Technologies H3C S6800 Series Switches User Manual
Page 27
14
Configuration restrictions and guidelines
•
For an LSP, the outgoing label specified on an LSR must be identical with the incoming label
specified on the downstream LSR.
•
LSPs are unidirectional. You must configure an LSP for each direction of the data forwarding path.
•
A route to the destination address of the LSP must be available on the ingress node and the egress
node, but it is not needed on transit nodes. Therefore, you do not need to configure a routing
protocol to ensure IP connectivity among all switches.
Configuration procedure
1.
Create VLANs and configure IP addresses for all interfaces, including the loopback interfaces, as
. (Details not shown.)
2.
Configure a static route to the destination address of each LSP:
# On Switch A, configure a static route to network 21.1.1.0/24.
[SwitchA] ip route-static 21.1.1.0 24 10.1.1.2
# On Switch C, configure a static route to network 11.1.1.0/24.
[SwitchC] ip route-static 11.1.1.0 255.255.255.0 20.1.1.1
3.
Configure basic MPLS on the switches:
# Configure Switch A.
[SwitchA] mpls lsr-id 1.1.1.9
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] mpls enable
[SwitchA-Vlan-interface2] quit
# Configure Switch B.
[SwitchB] mpls lsr-id 2.2.2.9
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] mpls enable
[SwitchB-Vlan-interface2] quit
[SwitchB] interface vlan-interface 3
[SwitchB-Vlan-interface3] mpls enable
[SwitchB-Vlan-interface3] quit
# Configure Switch C.
[SwitchC] mpls lsr-id 3.3.3.9
[SwitchC] interface vlan-interface 3
[SwitchC-Vlan-interface3] mpls enable
[SwitchC-Vlan-interface3] quit
4.
Configure a static LSP from Switch A to Switch C:
# Configure the LSP ingress node, Switch A.
[SwitchA] static-lsp ingress AtoC destination 21.1.1.0 24 nexthop 10.1.1.2 out-label
30
# Configure the LSP transit node, Switch B.
[SwitchB] static-lsp transit AtoC in-label 30 nexthop 20.1.1.2 out-label 50