Configuring a pw, Configuring a pw class, Configuring a static pw – H3C Technologies H3C S6800 Series Switches User Manual
Page 342: Configuring an ldp pw
329
Configuring a PW
Configuring a PW class
You can configure PW attributes such as the PW type and enable control word in a PW class. PWs with
the same attributes can reference the same PW class.
To configure a PW class:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create a PW class and enter
PW class view.
pw-class class-name
By default, no PW class is created.
3.
(Optional.) Enable control
word.
control-word enable
By default, control word is
disabled.
4.
(Optional.) Specify the PW
type.
pw-type { ethernet | vlan }
By default, the PW type is VLAN.
Configuring a static PW
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter cross-connect group
view.
xconnect-group group-name
N/A
3.
Enter cross-connect view.
connection connection-name N/A
4.
Configure a static PW and
enter cross-connect PW view.
peer ip-address pw-id pw-id
in-label label-value out-label
label-value [ pw-class class-name |
tunnel-policy tunnel-policy-name ] *
By default, no static PW is
configured.
Configuring an LDP PW
Before you configure an LDP PW, enable global and interface MPLS LDP on the PE. For information about
MPLS LDP configuration, see "
To configure an LDP PW:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter cross-connect group
view.
xconnect-group group-name
N/A
3.
Enter cross-connect view.
connection connection-name N/A