H3C Technologies H3C S6800 Series Switches - Manual (Page 350)

337
MPLS L2VPN configuration examples
Configuring a static PW
Network requirements
Create a static PW between PE 1 and PE 2 over the backbone so that CE 1 and CE 2 can communicate
within VLAN 10.
Figure 87 Network diagram
Table 29 Interface and IP address assignment
Device Interface IP address Device Interface IP address
PE 1 Loop0 192.2.2.2/32 P Loop0 192.4.4.4/32
Vlan-int20 10.1.1.1/24 Vlan-int30 10.2.2.2/24
PE 2 Loop0 192.3.3.3/32 Vlan-int20 10.1.1.2/24
Vlan-int30 10.2.2.1/24
Configuration procedure
Before you perform the following configurations, configure VLANs and add ports to VLANs.
1. Configure CE 1.
system-view
[CE1] interface fortygige 1/0/1
[CE1-FortyGigE1/0/1] port link-type trunk
[CE1-FortyGigE1/0/1] port trunk permit vlan 10
[CE1-FortyGigE1/0/1] quit
2. Configure PE 1:
# Configure an LSR ID.
system-view
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 192.2.2.2 32
[PE1-LoopBack0] quit
[PE1] mpls lsr-id 192.2.2.2
文件中找不到关系 ID 为 rId112 的图像部件。