H3C Technologies H3C S6800 Series Switches - Manual (Page 372)

359
Device Interface IP address Device Interface IP address
Vlan-int26 26.2.2.1/24
Configuration procedure
1. Configure CE 1.
system-view
[CE1] vlan 10
[CE1-vlan10] quit
[CE1] interface vlan-interface 10
[CE1-Vlan-interface10] ip address 100.1.1.1 24
[CE1-Vlan-interface10] quit
[CE1] interface fortygige 1/0/1
[CE1-FortyGigE1/0/1] port link-type trunk
[CE1-FortyGigE1/0/1] port trunk permit vlan 10
[CE1-FortyGigE1/0/1] quit
2. Configure PE 1:
# Configure an LSR ID.
system-view
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 192.2.2.2 32
[PE1-LoopBack0] quit
[PE1] mpls lsr-id 192.2.2.2
# Enable L2VPN.
[PE1] l2vpn enable
# Configure MPLS TE to establish an MPLS TE tunnel between PE 1 and P. For more information,
see " Configuring MPLS TE ."
# Create VLAN 10 and assign FortyGigE 1/0/1 to the VLAN.
[PE1] vlan 10
[PE1-vlan10] port fortygige 1/0/1
[PE1-vlan10] quit
# Create service instance 1000 on FortyGigE 1/0/1 to match packets that have an outer VLAN
ID of 10.
[PE1] interface fortygige 1/0/1
[PE1-FortyGigE1/0/1] service-instance 1000
[PE1-FortyGigE1/0/1-srv1000] encapsulation s-vid 10
[PE1-FortyGigE1/0/1-srv1000] quit
[PE1-FortyGigE1/0/1] quit
# Create a cross-connect group named vpn1, create a cross-connect named ldp in the group, and
bind service instance 1000 on FortyGigE 1/0/1 to the cross-connect.
[PE1] xconnect-group vpn1
[PE1-xcg-vpn1] connection ldp
[PE1-xcg-vpn1-ldp] ac interface fortygige1/0/1 service-instance 1000
# Create an LDP PW for the cross-connect to bind the AC to the PW.
[PE1-xcg-vpn1-ldp] peer 192.4.4.4 pw-id 1000
[PE1-xcg-vpn1-ldp-192.4.4.4-1000] quit
[PE1-xcg-vpn1-ldp] quit