H3C Technologies H3C S6800 Series Switches User Manual

Page 110

[SwitchC-bgp-ipv4] peer 20.1.1.1 enable

[SwitchC-bgp-ipv4] import-route ospf

[SwitchC-bgp-ipv4] import-route direct

[SwitchC-bgp-ipv4] quit

[SwitchC-bgp] quit

# Execute the display ip routing-table command on each switch to verify that the switches have

learned AS-external routes. Take Switch A as an example:

[SwitchA] display ip routing-table

Destinations : 10 Routes : 10

Destination/Mask Proto Pre Cost NextHop Interface

1.1.1.9/32 Direct 0 0 127.0.0.1 InLoop0

2.2.2.9/32 OSPF 10 1 10.1.1.2 Vlan1

3.3.3.9/32 O_ASE 150 1 10.1.1.2 Vlan1

4.4.4.9/32 O_ASE 150 1 10.1.1.2 Vlan1

10.1.1.0/24 Direct 0 0 10.1.1.1 Vlan1

10.1.1.1/32 Direct 0 0 127.0.0.1 InLoop0

20.1.1.0/24 O_ASE 150 1 10.1.1.2 Vlan1

30.1.1.0/24 O_ASE 150 1 10.1.1.2 Vlan1

127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0

127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0

Configure an LSR ID, and enable MPLS, MPLS TE, and RSVP-TE:
# Configure Switch A.

[SwitchA] mpls lsr-id 1.1.1.9

[SwitchA] mpls te

[SwitchA-te] quit

[SwitchA] rsvp

[SwitchA-rsvp] quit

[SwitchA] interface vlan-interface 1

[SwitchA-Vlan-interface1] mpls enable

[SwitchA-Vlan-interface1] mpls te enable

[SwitchA-Vlan-interface1] rsvp enable

[SwitchA-Vlan-interface1] quit

# Configure Switch B.

[SwitchB] mpls lsr-id 2.2.2.9

[SwitchB] mpls te

[SwitchB-te] quit

[SwitchB] rsvp

[SwitchB-rsvp] quit

[SwitchB] interface vlan-interface 1

[SwitchB-Vlan-interface1] mpls enable

[SwitchB-Vlan-interface1] mpls te enable

[SwitchB-Vlan-interface1] rsvp enable

[SwitchB-Vlan-interface1] quit

[SwitchB] interface vlan-interface 2

[SwitchB-Vlan-interface2] mpls enable

This manual is related to the following products: