Teac DP-24 - Manual (Page 94)

94
TASCAM DP-24
16 – Messages
Master File Not
Found
Master file could not be found.
This message appears if you try to enter Mastering mode, but you have not made any
mixdown recording yet. First perform a mixdown recording.
Master Track Too
Large
The master file is too large.
You tried to create a master file that is larger than the remaining available space on the SD
card.
Format the SD card (see "Quick formatting an SD card" on page 78 and "Full formatting an SD
card" on page 79), or connect the unit to a computer and delete unnecessary files to create
available space in the card.
MBR Error Init
CARD
The formatting of the card is abnormal or corrupted. Replace the card or format the card using
the
FORMAT
menu.
Execution of formatting erases all data currently on the card.
No Card No SD card is in the unit. Load a recordable SD card.
No Armed Track
There is no track in recording standby.
You tried to enter auto punch mode or press the RECORD button when no tracks were in
record standby. (See "Auto punch in/out" on page 57.)
Put a track into record standby before pressing the RECORD button or entering the auto
punch mode.
No Undo History
There is no undo history.
There are no actions to be undone. (See "Undoing an operation" on page 50.)
Not Stopped
The recorder is not stopped.
When the recorder is not stopped, this message appears when you press a button that works
only when the recorder is stopped, such as the UNDO/REDO button, etc.
Now Recording
A recording is being performed.
This message appears when you try to operate a menu while a recording is being performed.
There are also other operations that are not allowed during a recording.
OUT point must
be set after the
IN point.
You cannot set the OUT point before the IN point. Set the OUT point after the IN point.
Protected Card
The inserted SD card is write-protected.
To record or edit, turn off the unit and unprotect the SD card.
Recorded Track
Not Found
During execution of the export menu, the current song has no tracks recorded in it.
No tracks are recorded in the current song, or virtual tracks are not assigned to physical tracks.
Select a recorded song, assign the track you want to export to a physical track, and then export
it. (See "Virtual tracks" on page 59.)
Revert to discard
changes.
Editing and changes made from when loaded will be cleared, and reset to the same status as
when loaded. Proceed only when you are sure you wish to clear these changes.
Same Track
The same track has been specified.
This message appears in the clone track setting, when the same track is specified.
Song Protected
The song is protected.
The song is protected and you are trying to change it (record, edit, etc.). (See "Protecting
songs" on page 41.)
Unprotect the song.
Stereo Track
Full
The stereo track is already recorded.
This message appears if you try to import a stereo file when a stereo track is already recorded
in the song.
Track Full
The track is already recorded.
This message appears if you try to import a file when all tracks already have recordings. (See
"Importing tracks" on page 82.)
Trk Edit Fail
Track edit failed.
Save the song and turn the unit off and then on, and perform track edit again.
Trk Too Short
The track is too short.
You are trying to start a record in mixdown mode, but the time between the IN and OUT points
is too short. The IN and OUT points must be at least 4 seconds apart. (See "Setting IN/OUT
points" on page 56.)
Turn off the
Guitar Effect or
use two or less
Dynamic Effects.
While using a guitar effect, the use of dynamic effects is limited to only 1–2 channels. To use
dynamic effects on 3 or more channels, turn the guitar effect OFF.