Teac DP-24 - Manual (Page 57)

TASCAM DP-24
57
7 - Recorder Functions
3. Use the CURSOR (5/b) buttons to select (blue
highlight)
Jump Back
, then use the JOG/DATA
dial to set the value for the jump back playback.
Options:
1 Sec
to
10 Sec
,
20 Sec
,
30 Sec
(Default:
3 Sec
)
4. After making the settings, press the HOME button
to return to the Home screen.
5. Press the JUMPBACK button during playback to
move back by the time set in step 3.
Checking cueing points (preview)
You can perform a playback to check whether the cueing
is appropriately performed.
1. When the recorder is stopped, press the MENU
button to open the
MENU
screen.
2. Use the JOG/DATA dial or the CURSOR (5/b/g/t)
buttons to select (green highlight)
PREFERENCE
,
and then press the F4 (t) button.
The
PREFERENCE
screen appears.
3. Use the CURSOR (5/b) buttons to select (blue
highlight)
Preview Time
, then use the JOG/
DATA dial to set the value for the preview playback.
Preview Time:
1 Sec
to
10 Sec
(1 sec increments) (Default:
4 Sec
)
4. After making the settings, press the HOME button
to return to the Home screen.
5. Perform preview playback using either of the
following methods:
While playback is stopped, holding the PREVIEW
button and pressing the OUT button plays from the
current time by the preview time, returns, and then
stops.
While playback is stopped, holding the PREVIEW
button and pressing the IN button plays from the time
returned by the preview time to the current time, and
then stops.
Auto punch in/out
You can use the punch in/out function to perform an
automatic record from the punch in to the punch out
points you previously set .
When performing the auto punch in/out recording, the
playback starts from the pre-roll point before the start
recording point (punch in point) and when punch in
point is reached, the record starts. After that, when the
recording end point (punch out point) is reached, the unit
switches to the playback of the post-roll part and stops.
In the auto punch in/out recording, the recording track
monitor changes as follows.
Pre-roll period: Track playback signal + input source •
signal
Punch in
• a q punch out interval: Input source signal
Post-roll period: Track playback signal + input source •
signal
In the auto punch in/out function of this unit, the above
monitoring changes occur not only during the actual
recording, but also in the Rehearsal mode.
In Rehearsal mode, you can simulate the auto punch
in/out recording. Therefore, you can rehearse your
performance and also check whether the IN point and
OUT point are appropriately set.
You can also use the punch in/out in combination with the
repeat function. By using these functions in combination,
you can repeatedly rehearse the punch in/out recording,
or record the same section several times (multi-take),
leaving the unit working automatically to you. When
performing multitrack recording, you can choose the best
from recorded takes.