Teac DP-24 - Manual (Page 89)

TASCAM DP-24
89
14 - Using CDs
1. When Recorder mode is
Multi Track
mode,
press the CD button to open the
CD
menu screen.
2. Place a blank CD (unused CD-R/CD-RW disc or a
completely erased CD-RW) on the disc tray.
NOTE
If you put a CD-R/CD-RW that has been used previously
to write tracks using Track At Once and has not been
finalized, you can add another track to it. In this case,
the pop-up window for erasing a CD-RW disc does not
appear.
3. Use the JOG/DATA dial to select (blue highlight)
MASTER WRITE
and then press the F4 (t) button.
This opens the
MASTER WRITE
screen and shows
a list of songs that have been recorded in master files.
Master files that are not recorded at
44.1kHz
or
16bit
are not displayed.
4. Use the JOG/DATA dial to select (blue highlight)
only one song to write to the CD-R/CD-RW, and
then press the F2 (4) button.
A check mark 4 appears in the check box next to the
selected song.
NOTE
To remove the check mark 4 from a check box, press
the F2 (4) button again while the song is selected (blue
highlight).
5. Press the F4 (t) button.
A pop-up window asking whether you want to
perform the finalize process appears when the writing
is completed.
TIP
Finalize the disc if you do not plan to add any more tracks
to the CD-R/CD-RW. (See "Finalizing a CD" on page 90.)
6. To finalize, use the JOG/DATA dial to select
ON
,
otherwise, select
OFF
, and then press the F4 (t)
button again. (Default:
OFF
)
The confirmation message shown below appears.
7. Press the F2 (
YES
) button to begin writing to the
CD-R/CD-RW.
Using LIVE WRITER
1. When Recorder mode is
Multi Track
mode,
press the CD button to open the
CD
menu screen.
2. Place a blank CD (unused CD-R/CD-RW disc or a
completely erased CD-RW) on the disc tray.
3. Use the JOG/DATA dial to select (blue highlight)
LIVE WRITER
and then press the F4 (t) button.
This opens the
LIVE WRITER
screen where you
can divide a master file by setting position marks to
it. Master files that are not recorded at
44.1kHz
,
16bit
, are not displayed.
At this time, if there is no master file created or if no
mark has been set, the messages appear.