Teac DP-24 - Manual (Page 84)

84
TASCAM DP-24
14 - Using CDs
Using the CD drive
This unit has a CD drive that supports writing to CD-R and
CD-RW discs. In addition to playing back Audio CDs (CD-
DA), the unit's CD drive can also be used for the following
purposes.
Create an Audio CD from the master file. •
Import tracks from Audio CDs into the current song. •
CAUTION
When creating a CD from a master file, set to
44.1kHz
,
16bit
to create a song.
Preparations before using CDs with
this unit
When using CDs with this unit, make the following
preparations.
Before using a CD, change the recorder mode to •
Multi Track
. In modes other than
Multi
Track
, you cannot open the
CD
menu screen.
In
Mixdown
or
Mastering
mode, press the
MIXDOWN/MASTERING button repeatedly until the
unit switches to
Multi Track
mode.
In
Bounce
mode, press the BOUNCE button to switch
to the
Multi Track
mode.
Open the • CD
menu screen before inserting or ejecting
a CD.
In order to prevent the sound of the CD drive being
operated during recording, for example, the power
to the drive is disabled when in modes other than CD
mode. For this reason, it is necessary to put the unit
into CD mode in order to load or eject a CD. Even in CD
mode, a CD cannot be loaded or ejected after being
mounted. (Except for
CD
menu screen)
Since CD mounting is canceled in screens other than
CD
menu screen, load or eject a CD in the
CD
menu
screen or
CD PLAYER
screen.
Types of CDs that can be used with
this unit
This unit is compatible with 12-cm and 8-cm CD, CD-R,
CD-RW and CD-RW High Speed discs. This unit does not
support CD-RW Ultra Speed or CD-RW Ultra Speed+ discs.
For the functions that can be used with discs and the
types of compatible discs, see "Media Compatibility Table"
on page 91.
Writing to an already written CD-RW ª
With this unit, you do not need to erase a CD-RW
beforehand. You can use a previously written CD-RW by
erasing it at the beginning of the desired operation.
When creating an Audio CD, the following message will
appear if you load an already written CD-RW disc.
Confirmation message
Press the F2 (
Yes
) button to erase the songs recorded on
the disc.
If you do not want to erase the CD-RW disc, press the F1
(
NO
) button. The disc tray will open slightly. Pull the tray
out and replace the disc with another one.
CAUTION
If you use Track At Once to write a master file to an
unfinalized CD-RW in Audio CD format (a CD-RW created
by selecting a single master file on the MASTER WRITE
screen and setting FINALIZE to OFF), the file will be added
without showing the CD-RW erasure warning, and it will
not overwrite existing data on the disc.