Teac DP-24 - Manual (Page 85)

TASCAM DP-24
85
14 - Using CDs
Loading and ejecting CDs
Place the disc on the disk tray on the front panel.
1. When Recorder mode is
Multi Track
mode,
press the CD button to open the
CD
menu screen.
2. Press the F3 (-) button or the disc tray eject
button on the front panel to open the tray slightly.
Pull the tray out until it opens completely as shown
below.
CAUTION
Pull the tray out completely. If you try to load a disc •
into the tray or remove a disc from it when it is not
open completely, the disc could be scratched, making
it unusable.
Do not touch the writable side of a disc (the unlabeled
•
side). Doing so could cause it to become dirty or
scratched, making it unusable.
Loading a CD
1. As shown in the illustration, hold the edge of the
disc with the label side up and put it into the tray
so that its central hole is on the round protrusion in
the center of the tray.
2. Press the disc gently near the center to set it on the
tray.
The disc should click into place and be level with the
tray.
3. Push the tray to close it. The tray will click when
shut.
When a disc is not properly loaded ª
Pull the tray out completely once, reload the disc properly
and push the tray closed again. (If you force the disc in,
the unit or the disc could be damaged.)