Super Systems 3 Series - Manual (Page 90)

Operations Manual Series 3
90
14.4 Calibration Parameters
The following table gives the parameters available in the Calibration List.
The User Calibration is available in Level 3 only and is used to calibrate ‘Offset’
CALIBRATION PARAMETER LIST ‘cAL’
Name Scrolling
Display Parameter
Description Value Default Access Level
u c a l USER
CALIBRATION To select low and high
offset state or reset to no
offsets.
IdLe
Normal operating state IdLE L3 only
Lo
Low offset
Hi
High offset
rEST
Remove high and low offsets
The following parameters appear when calibrating the controller ie UCAL = Lo or Hi
c . a d j CALIBRATION
ADJUST To set an offset value. -1999 to 9999 L3 only
Input and Output calibration can only be done in Conf level.
CALIBRATION PARAMETER LIST ‘cAL’
Name Scrolling
Display Parameter
Description Value Default Access
Level
p h a s e CAL PHASE To calibrate low and high
offset
none
Not selected none Conf only
0 Select mV low calibration point
50 Select mV high calibration point
150r Select PRT low cal point
400r Select PRT high cal point
CJC Select CJC calibration
Ct 0 Select CT low cal point
Ct 70 Select CT high cal point
Fact Return to factory settings
Ima.L Low mA output from I/O 1
Ima.H High mA output from I/O 1
2ma.L Low mA output from output 2
2ma.H High mA output from output 2
3ma.L Low mA output from output 3
3ma.H High mA output from output 3
G O
To start the calibration
sequence
NO NO
Conf only
Yes Start
Busy Calibrating
Pass Calibration successful
faiL Calibration unsuccessful