Super Systems 3 Series - Manual (Page 77)

Series 3 Operations Manual
77
Parameter
Mnemonic Parameter Name Modbus Address
Decimal
4 – B Type Thermocouple
5 – N Type Thermocouple
6 – T Type Thermocouple
7 – S Type Thermocouple
8 – RTD
9 – millivolt
10 – Comms Input (see Modbus address 203)
11 – Custom Input (Downloadable)
CJ.tyP CJC Type
0 – Auto
1 – 0 Degrees C
2- 50 Degrees C 12291
mV.HI Linear Input High 12306
mV.LO Linear Input Low 12307
L.TYPE Logic Input A channel hardware type
0 – None
1 – Logic Inputs 12352
L.D.IN Logic input A function
40 – None
41 – Acknowledge all alarms
42 – Select SP1/2
43 – Lock All Keys
44 – FEATURE UNAVAILABLE
45 – FEATURE UNAVAILABLE
46 – FEATURE UNAVAILABLE
47 – FEATURE UNAVAILABLE
48 – Auto/Manual Select
49 – Standby Select
50 – Remote setpoint
51 – Recipe select through IO1
52 – Remote key UP
53 – Remote key DOWN 12353
L.SENS Configures the polarity of the logic input channel A (0 = Normal, 1 = Inverted) 12361
L.TYPE (LB) Logic Input B channel hardware type
0 – None
1 – Logic Inputs
12368
L.D.IN (LB) Logic input B function
40 – None
41 – Acknowledge all alarms
42 – Select SP1/2
43 – Lock All Keys
44 – FEATURE UNAVAILABLE
45 – FEATURE UNAVAILABLE
46 – FEATURE UNAVAILABLE
47 – FEATURE UNAVAILABLE
48 – Auto/Manual Select
49 – Standby Select
50 – Remote setpoint
51 – Recipe select through IO1
52 – Remote key UP
53 – Remote key DOWN 12369
L.SENS (LB) Configures the polarity of the logic input channel B (0 = Normal, 1 = Inverted) 12377
BAUD Baud Rate
0 – 9600
1 – 19200
2 – 4800
3 – 2400
4 – 1200 12548
PRTY Parity setting
0 – None
1 – Even
2 – Odd 12549
DELAY RX/TX Delay – (0 = no delay, 1 = delay) Select if a delay is required between received and transmitted comms messages.
Sometimes required when intelligent EIA232 adaptors are used. 12550
RETRN Comms Retransmission Variable selection:
0 – Off 12551