Super Systems 3 Series - Manual (Page 29)

Series 3 Operations Manual
29
6.4 Access Parameters
The following table summarizes the parameters available under the ACCESS list header
!
The Access List can be selected at any time when in configuration level by holding  key down for 3 seconds, then
press  or  with  still held down.
ACCESS LIST ‘ A C C S ’
Name Scrolling Display Parameter Description Values Allowed Default Access Level
G O T O SELECT ACCESS
LEVEL Allows you to change the access level of the
controller. Passwords prevent unauthorised
change Lev.1 Operator level 1
Lev.1
Conf
Lev.2
Operator level 2
Lev.3 Operator level 3
Conf Configuration level
LEV2.P
LEVEL 2 PASSCODE The Level 2 passcode
0-9999
0 = no passcode will be requested
2 Conf
LEV3.P LEVEL 3 PASSCODE The Level 3 passcode
3 Conf
CONF.P CONFIG PASSCODE To set a Configuration level passcode
4
Conf
I D CUSTOMER ID To set the identification of the controller 0-9999 Conf
H O M E HOME DISPLAY See
Note 1 To configure the parameter to be displayed
in the lower line of the HOME display Std Setpoint
Std Conf
OP Output demand
Tr Time remaining
ELAP
Time elapsed
AL Alarm 1 setpoint
Ct Current transformer
CLr No parameter
tmr Time remaining
t.sp Target setpoint
no.PV
PV is not displayed
Stby PV is not displayed when the
controller is in standby mode
K . L O C KEYBOARD LOCK To limit operation of the front panel buttons
when in operator levels.

If ALL has been selected, then to
restore access to the keyboard, power up
the controller with the

button held
down and enter the configuration level
passcode. This will take you to the Quick
Code mode. Press

to EXIT and select
YES . The front panel buttons can then be
operated as normal.
none Unlocked
none Conf
ALL All buttons locked
Edit Edit keys locked See Note 2
Mod
Mode keys locked See Note 3
Man Manual mode locked
Stby Press  and  to toggle
between normal operation and
standby mode
tmr FEATURE UNAVAILABLE
C O L D COLD START
ENABLE/ DISABLE Use this parameter with care.
When set to yes the controller will return to
factory settings on the next power up
No Disable No Conf
YES
Enable
s t b y . t STANDBY TYPE Turn ALL outputs off when the controller is
in standby mode. Typical use when event
alarms are used to interlock a process.
Abs.a
Absolute alarms to remain active
abs.a
Conf
Off
All alarms off in standby
m e t e r METER
CONFIGURATION
See Note 4
To configure the analogue meter to indicate
any one of the parameters listed.
OFF Meter display disabled Conf
HEAT
Heat Output demand
COOL Cool output demand
w.sp Working setpoint
pV Process value
Op Heat output demand
C.OP Cool output demand
err Error (SP – PV)
amps Output current
LCur Load current from CT
Note 1
Home Display Configuration
The upper display always shows PV, the lower display is
configurable.
Std
In automatic control the lower display shows setpoint.
In manual mode output power is shown.
OP
Output power is shown in both automatic and manual
modes.
AL1
First configured alarm setpoint
Ct CT current
CLr
Blank display
no.pv The upper display is blank
Stby The upper display blanks when the controller is in
standby mode.
Note 2
Edit keys locked. Parameters cannot be changed but
viewed only.