Super Systems 3 Series - Manual (Page 74)

Operations Manual Series 3
74
Parameter
Mnemonic Parameter Name Modbus Address
Decimal
Remote setpoint in percent 277
REM.HI Remote input high scalar – sets high range for setpoint input, corresponding to 20mA or 10V depending on the input type. 278
REM.LO Remote input low scalar – sets low range for setpoint input, corresponding to 4mA or 0V depending on the input type. 279
ROP.HI Sets the high range limit for the retransmitted setpoint. Allows a subset of the setpoint range to be retransmitted, and also
allows the setpoint range meter to display a range indication other than full scale. By default this is set to the setpoint high
limit. 280
ROP.LO Sets the low range limit for the retransmitted setpoint. Allows a subset of the setpoint range to be retransmitted, and also
allows the Series 3 setpoint range meter to display a range indication other than full scale. By default this is set to the setpoint
low limit. 281
A1.STS Alarm 1 Status (0 = Off, 1 = Active) 294
A2.STS Alarm 2 Status (0 = Off, 1 = Active) 295
A3.STS Alarm 3 Status (0 = Off, 1 = Active) 296
A4.STS Alarm 4 Status (0 = Off, 1 = Active) 297
LD.ALM Low Load Current Threshold 304
LK.ALM High Leakage Current Alarm (0 = Off, 1 = Active) 305
HC.ALM Over Current Alarm Threshold 306
LOAD.A Load Alarm Status (0 = Off, 1 = Active) 307
LEAK.A Leak alarm Status. 308
HILC.A Over Current alarm Status (0 = Off, 1 = Active) 309
REC.NO FEATURE NOT AVAILABLE 313
StOrE FEATURE NOT AVAILABLE 314
TM.CFG FEATURE NOT AVAILABLE 320
TM.RES FEATURE NOT AVAILABLE 321
SS.SP Soft Start Setpoint 322
SS.PWR Soft Start Power Limit 323
DWELL FEATURE NOT AVAILABLE 324
T.ELAP FEATURE NOT AVAILABLE 325
T.REMN FEATURE NOT AVAILABLE 326
THRES FEATURE NOT AVAILABLE 327
End.T FEATURE NOT AVAILABLE 328
SERVO FEATURE UNAVAILABLE 329
EVENT FEATURE NOT AVAILABLE 331
P.CYCL FEATURE NOT AVAILABLE 332
CYCLE FEATURE NOT AVAILABLE 333
CTRL.H Heat/Ch1 Control Type
0 – Off
1 – On/Off Control
2 – PID Control
3 – mtr Valve Position Control 512
CTRL.C Cool/Ch2 Control Type
0 – Off
1 – On/Off Control
2 – PID Control 513
PB.UNT Proportional Band Units
0 – Engineering Units
1 – Percent of Span 514
Lev2.P Level 2 Code 515
UNITS
Display Units
0 – Degrees C
1 – Degrees F
2 – Kelvin
3 – None
4 – Percent 516
Lev3.P Level 3 Code 517
Conf.P Config Code 518
Cold If set to 1 instrument will reset to factory defaults on next reset or power cycle. 519
PASS.C Feature passcode C 520
PASS.2 Feature passcode 2 521
COOL.t Cooling Algorithm Type: 524