Super Systems 3 Series - Manual (Page 76)

Operations Manual Series 3
76
Parameter
Mnemonic Parameter Name Modbus Address
Decimal
PNT.LO Adjust Low Point 563
CT.RNG CT Range 572
Sb.tyP
Sensor Break Type
0 – No Sensor Break
1 – Non-Latching Sensor Break
2 – Latching Sensor Break 578
Id Customer ID – May be set to any value between 0-9999 for identification of instruments in applications. Not used by the
instrument itself. 629
PHASE
Calibration Phase
0 – None
1 – 0 mv
2 – 50 mv
3 – 150 Ohm
4 – 400 Ohm
5 – CJC
6 – CT 0 mA
7 – CT 70 mA
8 – Factory Defaults
9 – Output 1 mA low cal
10 – Output 1 mA high cal
11 – Output 2 mA low cal
12 – Output 2 mA high cal
13 – Output 3 ma low cal
14 – Output 3 ma high cal
15 – Remote setpoint input low volts
16 - Remote setpoint input high volts
17 - Remote setpoint input low current
18 - Remote setpoint input high current 768
GO Calibration Start
0 – No
1 – Yes (start cal)
2 – Cal Busy
3 – Cal Pass
4 – Cal Fail
Note values 2-4 cannot be written but are status returns only 769
- Analogue Output Calibration Value 775
K.LOC Allows instrument to be locked via a key/digital input
0 - unlocked,
1 – all keys locked
2 – Edit keys (raise and lower) disabled
3 – Mode key disabled
4 – Manual mode disabled
5 – Enter standby mode when Mode combination pressed 1104
Dwel.1 FEATURE NOT AVAILABLE 1280
TSP.1 FEATURE NOT AVAILABLE 1 1281
RMP.1 FEATURE NOT AVAILABLE 1282
Dwel.2 FEATURE NOT AVAILABLE 1283
TSP.2 FEATURE NOT AVAILABLE 1284
RMP.2 FEATURE NOT AVAILABLE 1285
Dwel.3 FEATURE NOT AVAILABLE 1286
TSP.3 FEATURE NOT AVAILABLE 3 1287
RMP.3 FEATURE NOT AVAILABLE 3 1288
Dwel.4 FEATURE NOT AVAILABLE 1289
TSP.4 FEATURE NOT AVAILABLE 4 1290
RMP.4 FEATURE NOT AVAILABLE 1291
AT.R2G Auto-tune Configures R2G
0 - YES
1 - No 4176
IN.TYP Input Sensor Type
0 – J Type Thermocouple
1 – K Type Thermocouple
2 – L Type Thermocouple
3 – R Type Thermocouple 12290