Super Systems 3 Series - Manual (Page 39)

Series 3 Operations Manual
39
9.1.7 Output List 2 (OP-2)
This is an optional normally open relay and is available on terminals 2A and 2B. The way in which this output operates is
determined by parameters in the OP- 2 List. OP2 beacon is operated from this output channel.
OUTPUT LIST 2 ‘op-2’
Name Scrolling
Display
Parameter Description Value Default Access Level
2 . i d OUTPUT 2
TYPE Output channel 2 hardware
type
reLy
Relay output
As
ordered Read only
2.FUNC FUNCTION Output channel 2 function
If the instrument is ordered as
valve positioner (codes VC or
VP), only options available are ,
none, d.out, UP
, or dwn
Note: If output 2 is set to Up
ensure the other valve
position output is set to dwn
and vice versa
none Disabled. If disabled no further parameters are
shown As
ordered Conf
d.out Digital output
Heat Heat output
CooL Cool output
2.SRC.A I/O 2 SOURCE A These parameters only appear
when the channel function is a
Digital OP,
i.e. 2.FUNC = d.Out
Selects an event status to be
connected to the output
channel.
The output status is the result
of an OR of Src A, Src B, Src C,
and Src D
Up to four events can,
therefore, operate the output
none No event connected to the output none Conf
AL1 Alarm 1 *
2.SRC.B I/O 2 SOURCE B AL2 Alarm 2 *
AL3 Alarm 3 *
2.SRC.C I/O 2 SOURCE C AL4 Alarm4 *
ALL.A All alarms
2.SRC.D
I/O 2 SOURCE D
nw.AL
Any new alarm
Ct.AL CT alarm, load, leak & overcurrent
Lbr Loop break alarm
Sbr Sensor break alarm
mAn Manual status
rmt.F Remote fail
Pwr.f Power fail
prg.e FEATURE UNAVAILABLE
2.SENS SENSE To configure the polarity of
output channel 2
nor Normal nor Conf
* The mnemonic for the alarm will change depending upon the alarm configuration.
9.1.8 Output List 3 (OP-3)
This is a normally 4-20 or 0-20mA isolated dc output. The way in which this output operates is determined by parameters in the
OP- 3 List. OP3 beacon is operated from this output channel.
OUTPUT LIST 3 ‘op-3’
Name Scrolling
Display
Parameter Description Value Default Access Level
3 . i d OUTPUT 3
TYPE Output channel 3 hardware
type
nonE
Output not fitted As ordered Read only
dC.Op
0-20mA output See note 1
3.FUNC FUNCTION Output channel 3 function
If the instrument is ordered as
valve positioner (codes VC or
VP), only options available are ,
none, d.out, UP
, or dwn
Note: If output 3 is set to Up
ensure the other valve
position output is set to dwn
and vice versa
none Disabled. If disabled no further
parameters are shown d.out Conf
Heat Heat output
CooL Cool output
w.sp Working setpoint re-transmission Shown if I/O 3 TYPE = dc.OP
Retransmission
pV Process variable re-transmission
Op Output re-transmission
Inv Inverted
3.rng DC OUTPUT
RANGE DC output calibration.
Only shown if
3 . i d = dC.Op 4.20 4-20mA 4.20 Conf
0.20 0-20mA
Note 1: A DC output may require calibration.