RLE Falcon EM - Manual (Page 89)

User Guide: Falcon FMS Communication
www.rletech.com 970 484-6510 75
Figure 5-15: Modbus Register Configuration Menu
Selecting a link to an individual register displays the configuration options for that register; see Figure 5-
16. Instructions for completing the options on this page are described below.
Figure 5-16: Individual Modbus Configuration Screen
Unit: Enter the Slave Unit Number. This is NOT the Slave address, but the Slave Unit Number shown on
the Modbus Slave Unit Configuration page; see Figure 5-13, pg. 73.
Register: Enter the Register Number for the data to be read. The Register Number is located on the Slave
Units Modbus Register Map; see section 5-8.1 Slave Register Map, pg. 80.
Type: Select the Data Type of the Register.
 Unsigned Int
 Signed Int
 Long
 Float
 Alarm Bit/ ON= ALARM
 Alarm Bit/ OFF=ALARM
 Status Bit – No Log
 Status Bit – Logged
 Coil Status
 Input Status
NOTE:
Refer to the manufacturers equipment guide for the register numbers and the data
type.