RLE Falcon EM - Manual (Page 103)

User Guide: Falcon FMS EIA232 Interface
www.rletech.com 970 484-6510 89
Table 6-1: EIA232 Main Menu
COMMAND DESCRIPTION FUNCTION
CA Current Alarms CA displays all active alarms on the master unit. If alarms
are present, the System Status LED is red.
KA Kill Alarms KA acknowledges all alarms and terminates all dial-out
communications and network Traps.
TI Display
Date/Time TI displays the FMS current time and date.
AD ADC Input
Values AD allows the user to examine the readings of the 4-20mA
inputs. These readings can be referenced during start-up to
verify gain and offset calculations. Data displayed depends
on the expansion card(s) installed.
MS Modem Statistics MS provides a summary of all modem information.
NS Network
Statistics NS displays network and EIA485 statistics including:
network packets received, packets transmitted, and errors.
SC Main
Configuration SC displays a submenu that lists all items for system setup
and configuration.
DU Dump Network
Packets DU dumps the headers of all network packets received and
sent. Only active until the next command is entered. This
item is for network debugging only and is not normally
enabled.
NT Network Trace NT displays troubleshooting messages during the
processing of network packets. Only active until the next
command is entered. Network Trace is for network
troubleshooting only and is not normally enabled.
PING PING Allows user to PING another device on the network.
EX Exit to
Bootloader EX is used to enter the Bootloader command section. The
unit will stop monitoring the inputs and allow firmware
updates to be loaded. To restore normal operation after
updating firmware, type run and press Enter on the
keyboard, or power the unit off and back on again.