OpenEye EasyDVR - Manual (Page 39)

30757AC 39
Sensitivity
Sensitivity allows you to change the sensitivity of motion detection function. A greater value represents
more sensitive detection (motion events will be easier to trigger).
Block Threshold
Block Threshold allows you to change the amount of motion needed to register a motion event. This
number represents the number of blocks on the 16x12 grid that are required to be detecting motion
before a motion event is registered. Selecting the minimum (1) means that only one block needs to be
detecting motion for it to register as a motion event. Selecting the maximum (16) means that sixteen
grid blocks need to be detecting motion for it to register as a motion event.
Configure the Recorder for Motion Based Recording
By default the recorder is configured to record continuously with the configuration of “Best Quality.”
To change to motion only recording:
1. Press MENU.
2. Select CAMERAS and press ENTER.
3. Select Motion Detection Setup and press ENTER.
4. Select Motion Detect and press ENTER.
5. Press DOWN arrow to change the selection to On and press ENTER.
6. Press ESCAPE.
7. Select Copy Settings and press ENTER.
8. Select Select All and press ENTER.
9. Select Confirm and press ENTER.
10. Press ESCAPE.
11. Select SCHEDULE and press ENTER.
12. Select Global Configuration and press ENTER.
13. Press UP arrow three times to change the selection to Event Only and then press ENTER.
14. Press ESCAPE.