Measurement Computing WaveBook rev.5.3 - Manual (Page 142)

The “Select Device Type” Dialog Box
This dialog box opens when the Add Device
button of the Device Inventory dialog box is
selected.
The device type you select for configuring
will appear in the main edit box. Clicking on
the OK button will then open the Properties
Dialog Box.
Daq Configuration - Select Device Type Dialog Box
Properties Dialog Box
This dialog box opens when the Properties button of the Device Inventory dialog box is selected, or when
the OK button of the Select Device Type dialog box is selected. It displays the properties for the WaveBook
device with the default configuration settings. The appearance of the Properties Dialog Box can vary,
depending on whether the WaveBook device connection is via parallel port or Ethernet, as indicated in the
following two figures. In addition, the box will have a third appearance for WaveBook devices that are
connected to an Expansion Port of a WaveBook/516E or WBK25 Ethernet Interface Module. A discussion
of the third Properties Box appearance is discussed shortly.
Configuring for Parallel Port Configuring for Ethernet*
Daq Configuration - Properties Dialog Boxes
*Note: The tab will not show WBK25 and WaveBook/516E at the same time.
A-2 Using the Daq Configuration Applet 897495 Appendix A