Wavebook/516a, /512a, and /516 – Measurement Computing WaveBook rev.5.3 User Manual
Page 138
9-2 Fuse Replacement
989396
WaveBook User’s Manual
WaveBook/516A, /512A, and /516
Observe the Cautions and the important note on page 9-1 prior to beginning this
fuse replacement procedure.
1. If you have not already done so, turn OFF the power to, and UNPLUG the WaveBook and all
connected equipment. Remove all signal I/O lines from the unit.
2. Using a Phillips screwdriver, remove the four Cover Plate Screws from the left and right sides
of the unit. The following figure points out the screw locations.
3. Remove the Cover Plate [not shown].
F201
F201 Fuse Location in WaveBook/516A, /512A, /516
Cover Plate
Screw Locations
Cover Plate
Screw Locations
4. Locate the F201 fuse. It is located near the rear panel edge, close to the DIN5 POWER IN connector.
5. While wearing a grounded wrist strap, remove and replace the bad fuse. Ensure that the new fuse is
fully seated.
6. Replace the Cover Plate and secure it to the chassis with the 4 screws that were removed in step 2.
7. Return the WaveBook to normal service. Should any problems be noted, consult the factory.