Measurement Computing ZonicBook 618E rev.3.4 - Manual (Page 97)

ZonicBook/618E 918895 Specifications 13-1
Specifications - ZonicBook/618E 13
Specifications are subject to change without notice.
General Specifications
Environment:
Operating: 0˚ to 50˚C, 0˚ to 95% RH, non-condensing
Storage: -20˚ to 70˚C
Power Consumption: 2.3A max @ 15 VDC
Input Power Range: 10 to 30 VDC
Vibration: MIL STD 810E, Categories 1 and 10
PC Communication: 10/100BaseT Ethernet
Dimensions: 285 mm W x 220 mm D x 70 mm H; (11” x 8.5” x 2.70”)
Weight: 2.38 kg (5.25 lbs.)
Warm-up: 30 minutes to rated specifications
Throughput rate: >2 Mbytes/s
Internal Data Storage: 1 Msample built-in, 64 Msample optional (factory installed)
SYNC Input: Reserved for future use.
Analog Specifications
Analog Inputs:
Channels: 8 single-ended input channels, expandable up to 56 channels via six WBK18 modules
Input Connector: 1 BNC per channel
Input Impedance: 200k Ohm (single-ended)
Input Coupling: AC or DC; software programmable per channel
High-Pass Filter: 0.1 Hz or 1 Hz; software programmable per channel
Input Ranges:
±25V (DC coupled only), ±5V, ±2.5V, ±1V, ±500mV, ±250mV, ±100mV, ±50mV, ±25mV;
software programmable per channel
Overrange Indication: Front panel LEDs, one per channel, software status
Low-Pass Filter (software programmable per channel)
Type: 8-pole Butterworth with simultaneous sample-and-hold (SSH)
Cutoff Frequency (Fc): 10 Hz to 200 kHz in 1-2-5 progression
Alias Rejection: 75 dB min
Channel-to-Channel Phase Matching*: 1
° typ, 2° max
Unit-to-Unit Phase Matching*: 1 ° typ, 2° max
SSH latency: 100ns max
Amplitude Accuracy**: ±0.5 dB (F
in
≤ F
c
/2)
Total Harmonic Distortion: -70 dB typ
ICP Bias Source: 4mA, 24V compliance (on/off software programmable per channel)
ICP Fault Detection Thresholds: <1V (short), >25V (open)
ICP Fault Indication: Front panel LED per channel, software status
Coupling: AC, AC with ICP; or DC. Programmable on a per-channel basis
* Conditions for Low-Pass Filter Phase-Matching
8-pole LPF mode, 0.1 Hz or DC HPF mode
1 Hz
≤ F
in
≤ F
c
/2
200 Hz ≤ F
c
≤ 20 kHz
** Condition for Amplitude Accuracy
For Fin < 20 kHz