Measurement Computing ZonicBook 618E rev.3.4 - Manual (Page 38)

5-4 System Setup and Power Options 947091 ZonicBook/618E User’s Manual
STEP 1
–
Install the Software
Install the software prior to connecting the ZonicBook/618E to the Ethernet. If you have not already installed the software,
do so at this time. Refer to the section entitled Software Installation, page 5-2.
STEP 2
–
Determine the type of Network Connection
To properly connect and configure a ZonicBook/618E, you must determine the type of network that the
device will become part of. This is because the type of network used has a direct bearing on the IP address
of the device.
Briefly, the four network types are as follows:
Dedicated Network - with a direct cable connection from the PC to the device
Dedicated Network - making use of a network hub or switch
LAN with a DHCP server
(Local Area Network with a Dynamic Host Configuration Protocol)
LAN without a DHCP server
(Local Area Network with no Dynamic Host Configuration Protocol)
Brief descriptions and illustrations follow.
Dedicated Network - with a direct cable connection from the PC to the device
In this scenario a ZonicBook/618E is connected directly to an Ethernet jack on a host computer.
Dedicated Network using a Direct Cable Connection