Measurement Computing ZonicBook 618E rev.3.4 - Manual (Page 104)

A-4 Using the Daq Configuration Applet 9873966 Appendix A
To set the properties of a ZonicBook/618E on a LAN with DHCP server.
a. Enter the base 10 version of the serial number of the ZonicBook/618E. The number is
located on the MAC label on the unit’s rear panel.
b. Get the IP address of the device from your network administrator. The network administrator
will need the unit powered-on and connected to the network. The administrator will also
need the MAC address label’s hexadecimal number (the label’s bottom number).
c. Select the “Manual IP Setting” radio button.
d. In the IP Address field, enter the IP address obtained from your network administrator.
To test the ZonicBook/618E connection.
a. Click the “Test Hardware” tab.
b. Click the <Resource Test> button.
c. Perform a TCP/IP test per Appendix B.