Measurement Computing ZonicBook 618E rev.3.4 - Manual (Page 112)

3. To manually initiate a charge cycle, press the START CHARGE momentary rocker-arm switch.
Note that subsequent charge cycles applied to a fully-charged DBK30A will have no ill effect.
The module will sense the fully-charged status and revert to the trickle-charge state within a few
minutes.
Three LEDs on the DBK30A provide status information on the charging process or the external load.
LED Indicators & Descriptions
POWER IN Indicates the charger is connected to a source of AC power and to the battery module.
BATTERY
CHARGING
Steady Light - Indicates the battery is in the high-current (2 A) charge mode.
Flashing - One or two flashes at a time indicates the batteries are fully charged.
POWER OUT Indicates power is flowing out to an external device, such as a ZonicBook/618E.
Periodically, fully discharge the DBK30A to inhibit “lazy chemistry” (memory) in the
nickel-cadmium cells. To manually discharge a battery pack, you can connect a
ZonicBook/618E to the pack and leave it powered-on until the indicator lights go out.
Use While Charging. Both operating modes are capable of powering the ZonicBook/618E products while
being charged; however, the charging current is reduced, and charging time is increased. If AC power is
interrupted, a new charge cycle will begin automatically when AC power returns.
Even with the AC adapter, the batteries will eventually discharge under a
ZonicBook/618E’s operating load. Charging DOES NOT BEGIN
AUTOMATICALLY (except on power-up). You must manually initiate the next
charge cycle. Do not expect a ZonicBook/618E powered by a DBK30A to operate as if
it had an uninterruptible power supply.
DBK30A Battery Module – Specifications
Name/Function: Rechargeable Battery Module
Battery Type: Nickel-cadmium
Number of Battery Packs: 2
Battery Pack Configuration: 12 series-connected sub-C cells
Output Voltage: 14.4 V or 28.8 V (depending on the selected mode)
Output Fuses: 2 A
Battery Amp-Hours: 3.4 A-hr (1.7 A-hr/pack)
Charge Termination: Peak detection
Charge Time: 2 hours
Charging Voltage from Supplied AC Adapter: 22 to 26 VDC @ 2 A
AC Adapter Input: 95 to 265 VAC @ 47 to 63 Hz
Size: 221 mm × 285 mm × 35 mm (11" × 8-1/2" × 1-3/8")
Weight: 2.4 kg (6 lb)
C-4 Power Options 977995 ZonicBook/618E User’s Manual