Standard Horizon HX-870 - Manual (Page 97)

Page 97 HX870
13.6.2 Water Hazard LED
1. Press the MENU key to display “MENU”.
DSC SETUP
GM SETUP
BACK
SETUP
WAYPOINT SETUP
CH SETUP
GPS SETUP
CONFIGURATION
SELECT
DIMMER
LAMP
CONTRAST
KEY BEEP
BATTERY SAVE
STROBE LED
SOFT KEY
CONFIGURATION
BACK SELECT
EMERGENCY LED
BACK
CONFIGURATION
WATER HAZARD LED
SELECT
STROBE LED
OFF
BACK
CONFIGURATION
ON
ON/PWR ON
SELECT
WATER HAZARD LED
2. Select “SETUP” with the CH▼/CH▲/◄/►
key, then press the [SELECT] soft key.
3. Select “CONFIGURATION” with the CH▼/
CH▲ key, then press the [SELECT] soft key.
4. Select “STROBE LED” with the CH▼/CH▲
key, then press the [SELECT] soft key.
5. Press the CH▼/CH▲ key to select “WATER
HAZARD LED ”, then press the [SELECT] soft
key.
6. Press the CH▼/CH▲ key to select the
desired setting. You can select one from
“OFF”, “ON”, or “ON/PWR ON”.
OFF
: The LED does not light up.
ON : The LED lights up.
ON/PWR ON : The LED lights up and the
transceiver turns on even if the
transceiver is off.
7. Press the [ENTER] soft key to store the selected setting.
8. Press the CLR key to return to radio operation.