Standard Horizon HX-870 - Manual (Page 102)

Page 102 HX870
14.5 SCAN RESUME
This selection is used to select the time the HX870 waits after a transmission
ends before the radio starts to scan channels again. The default setting is 2
seconds.
1. Press the
MENU key to display “MENU”.
DSC SETUP
GM SETUP
BACK
SETUP
WAYPOINT SETUP
CH SETUP
GPS SETUP
ATIS SETUP
SELECT
CH GROUP
WX ALERT
SCAN MEMORY
SCAN TYPE
SCAN RESUME
MULTI WATCH
PRIORITY CH
CH SETUP
BACK SELECT
ON
1sec
BACK
CH SETUP
2sec
3sec
4sec
5sec
ENTER
SCAN RESUME
2. Select “SETUP” with the CH▼/CH▲/◄/►
key, then press the [SELECT] soft key.
3. Select “CH SETUP” with the CH▼/CH▲ key,
then press the [SELECT] soft key.
4. Select “SCAN RESUME” with the CH▼/CH▲
key, then press the [SELECT] soft key.
5. Press the CH▼/CH▲ key to select the
desired resume time, default is 2 seconds.
The resume time can be set to “1sec”
through “5sec”.
6. Press the [ENTER] soft key to store the new
setting.
7. Press the CLR key to return to radio operation.
14.6 WATCH TYPE
This selection is used to select the watch type between “Dual Watch” and “Triple
Watch”. The default setting is “Dual Watch”.
Refer to section “ 8.8 MULTI WATCH (TO PRIORITY CHANNEL)” for details.
14.7 PRIORITY CHANNEL
This procedure allows the radio to use a different priority channel used when
priority scanning. By default the radio priority channel is set to Channel 16.
1. Press the
MENU key to display “MENU”.
DSC SETUP
GM SETUP
BACK
SETUP
WAYPOINT SETUP
CH SETUP
GPS SETUP
ATIS SETUP
SELECT
CH GROUP
WX ALERT
SCAN MEMORY
SCAN TYPE
SCAN RESUME
MULTI WATCH
PRIORITY CH
CH SETUP
BACK SELECT
ON
CH:
16
BACK
CH SETUP
CH:
17
CH:
18
A
CH: 19
CH: 20
ENTER
PRIORITY CH
2. Select “SETUP” with the CH▼/CH▲/◄/►
key, then press the [SELECT] soft key.
3. Select “CH SETUP” with the CH▼/CH▲ key,
then press the [SELECT] soft key.
4. Select “PRIORITY CH” with the CH▼/CH▲
key, then press the [SELECT] soft key.
5. Press the CH▼/CH▲ key to select the
desired channel to be a priority.
6. Press the [ENTER] soft key to store the new
setting.
7. Press the CLR key to return to radio opera-
tion.