Standard Horizon HX-870 - Manual (Page 18)

Page 18 HX870
6.2 BELT CLIP INSTALLATION / REMOVAL
1. To install, align the Belt Clip Clip-22 to the groove of
the Battery pack, then press the Belt Clip downward
until it locks in place with a “Click”.
2. To remove, pull the Clip-22 tab away from the
battery pack to unlock the Clip-22, then slide the
Clip-22 upward to remove it.
6.3 ATTACHING AN ANTENNA
Insert the CAT460 antenna into the ANT jack at the top
panel, hold the bottom end of the antenna, then screw
it onto the mating connector on the transceiver until it
is snug. Do not over-tighten.
2
1