Standard Horizon HX-870 - Manual (Page 96)

Page 96 HX870
13.5 BATTERY SAVER
This function allows you to change the battery save mode setting.
1. Press the
MENU key to display “MENU”.
DSC SETUP
GM SETUP
BACK
SETUP
WAYPOINT SETUP
CH SETUP
GPS SETUP
CONFIGURATION
SELECT
DIMMER
LAMP
CONTRAST
KEY BEEP
BATTERY SAVE
STROBE LED
SOFT KEY
CONFIGURATION
BACK SELECT
OFF
BACK
CONFIGURATION
50%
70%
80%
90%
ENTER
BATTERY SAVE
2. Select “SETUP” with the CH▼/CH▲/◄/►
key, then press the [SELECT] soft key.
3. Select “CONFIGURATION” with the CH▼/
CH▲ key, then press the [SELECT] soft key.
4. Select “BATTERY SAVE” with the CH▼/CH▲
key, then press the [SELECT] soft key.
5. Press the CH▼/CH▲ key to select the
desired setting. You can select one from
“OFF”, “50%”, “70%”, “80%”, or “90%”.
6. Press the [ENTER] soft key to store the
selected setting.
7. Press the CLR key to return to radio opera-
tion.
13.6 STROBE LED
This selection is used to switch and set the function of the strobe LED.
13.6.1 Emergency LED
1. Press the MENU key to display “MENU”.
DSC SETUP
GM SETUP
BACK
SETUP
WAYPOINT SETUP
CH SETUP
GPS SETUP
CONFIGURATION
SELECT
DIMMER
LAMP
CONTRAST
KEY BEEP
BATTERY SAVE
STROBE LED
SOFT KEY
CONFIGURATION
BACK SELECT
EMERGENCY LED
BACK
CONFIGURATION
WATER HAZARD LED
SELECT
STROBE LED
CONTINIUS
BACK
CONFIGURATION
SOS
BLINK1
BLINK2
BLINK3
SELECT
EMARGENCY LED
2. Select “SETUP” with the CH▼/CH▲/◄/►
key, then press the [SELECT] soft key.
3. Select “CONFIGURATION” with the CH▼/
CH▲ key, then press the [SELECT] soft key.
4. Select “STROBE LED” with the CH▼/CH▲
key, then press the [SELECT] soft key.
5. Press the CH▼/CH▲ key to select “EMER-
GENCY LED ”, then press the [SELECT] soft
key.
6. Press the CH▼/CH▲ key to select the
desired setting. You can select one from
“CONTINIOUS”, “SOS”, “BLINK 1”, “BLINK 2”,
or “BLINK 3”.
7. Press the [ENTER] soft key to store the
selected setting.
8. Press the CLR key to return to radio operation.