Standard Horizon HX-870 - Manual (Page 89)

Page 89 HX870
11.2.3 Changing the Destination
1. On the navigation screen, press ◄/►key,
then press the [NEXT TG] soft key.
SOG kph
36.0
DST km
35.2
BRG T
HI USA
RTE
N-UP 20nm
BUSY
300
25
°
DW-16
STOP FUNC NEXT TG
TARGET
WPT:KAREN
Via1:001WPT
DISPLAY RANGE
Via2:002WPT
ARRIVED RANGE
ROUTING OPERATION
ROUTE
BACK SELECT
SOG
kph
DST km
BRG T
Via2 002WPT
HI USA
RTE
N-UP 20nm
BUSY
300
25
°
DW-16
36.0
25.2
2. Press the CH▼/CH▲ key to select desired
destination.
3. Press the [SELECT] soft key. The navigation
screen with a new destination appears.
11.2.4 Selecting Automatic or Manual Routing
This selection allows you to start navigation to the next target automatically or
manually when your vessel has arrived at a target point.
1. Press the
MENU key to display “MENU”.
DSC SETUP
GM SETUP
BACK
SETUP
WAYPOINT SETUP
CH SETUP
GPS SETUP
ATIS SETUP
SELECT
MARK POSITION
WAYPOINT DIR.
ROUTE DIR.
DISPLAY RANGE
ARRIVAL RANGE
ROUTING OPERATION
WAYPOINT SETUP
BACK SELECT
AUTO
BACK
WAYPOINT SETUP
MANUAL
ENTER
ROUTING OPERATION
2. Select “SETUP” with the CH▼/CH▲/◄/►
key, then press the [SELECT] soft key.
3. Press the CH▼/CH▲ key to select “WAYPOINT
SETUP ”, then press the [SELECT] soft key.
4. Press the CH▼/CH▲ key to select “ROUTE
OPERATION ”, then press the [SELECT] soft
key.
5. Select “AUTO” or “MANUAL” with the CH▼/
CH▲ key, then press the [ENTER] soft key.
6. Press the CLR key to return to radio opera-
tion.