Standard Horizon HX-870 - Manual (Page 39)

Page 39 HX870
10.2.2 Programming the MMSI
WARNING
The MMSI can be inputted only once. Therefore please be careful
not to input the incorrect MMSI number. If you need to change
the MMSI number after it has been entered, the radio will have to be
returned to Factory Service. Refer to the section “ 16.2 FACTORY
SERVICE”.
1. Press the MENU key to display “MENU”.
MMSI/POS INFO
---------
MMSI
POS INFO
POS: --°--.---
-
---°--.---
-
POS TM: --:--
OK POS/TM MMSI
BACK SELECT FINISH
MMSI INPUT
MMSI
- ---------- 1st:
1 5 6 7 8 9 0 2 4
Delete
3
BACK SELECT FINISH
MMSI INPUT
MMSI
366900001 1st:
1 5 6 7 8 9 0 2 4
Delete
3
BACK SELECT FINISH
MMSI INPUT
MMSI
********* 1st:
366900001 2st:
1 5 6 7 8 9 0 2 4
Delete
3
OK
MMSI INPUT
MMSI
STORED MMSI!
366900001
2. Press the CH▼/CH▲/◄/► key to select
“MMSI/POS INFO”, then press the [SELECT]
soft key. (To cancel, press the [BACK] soft
key.)
3. Press the [MMSI] soft key.
4. Press the CH▼/CH▲/◄/► key to select
the first number of your MMSI, then press
the [SELECT] soft key to step to the next
number.
5. Repeat step 4 to set your MMSI number (9
digits).
6. If a mistake was made entering in the MMSI
number, press the CH▼/CH▲/◄/► key to
select “←” or “→”, press the [SELECT] soft
key until the wrong character is selected,
then perform step 4.
7. When finished programming the MMSI number, press the [FINISH] soft
key. The radio will ask you to input the MMSI number again. Perform steps
4 through 6 above.
8. After the second number has been input, press the [FINISH] soft key to
store the MMSI.
9. Press the [OK] soft key to return to radio operation.
NOTE
To view your MMSI after programming to ensure it is correct, perform
steps 1 to 2. Look that the MMSI number shown on the display is correct.