Standard Horizon HX-870 - Manual (Page 31)

Page 31 HX870
8.9.2 Programming Scan Memory
1. Press the MENU key to display “MENU”, then
select “SETUP” with the CH▼/CH▲/◄/►
key.
DSC SETUP
GM SETUP
BACK
SETUP
WAYPOINT SETUP
CH SETUP
GPS SETUP
CONFIGURATION
SELECT
CH GROUP
WX ALERT
SCAN MEMORY
SCAN TYPE
SCAN RESUME
MULTI WATCH
PRIORITY CH
CH SETUP
BACK SELECT
ON
CH:
16
BACK
CH SETUP
CH:
17
CH: 18 A
CH: 19
CH: 20
MEM
SCAN MEMORY
ON
ON
ON
2. Press the [SELECT] soft key, then press the
CH▼/CH▲/◄/► key to select “CH SETUP”.
3. Press the [SELECT] soft key, then press the
CH▼/CH▲ key to select “SCAN MEMORY”.
4. Press the [SELECT] soft key.
5. Press the CH▼/CH▲ key to select a desired
channel to be scanned, then press the
[MEM] soft keys. “ON” icon will appear at
the right side of the selected channel.
6. Repeat step 5 for all the desired channels
to be scanned.
7. To REMOVE a channel from the list, select the channel then press the
[MEM] soft key. “ON” icon of the selected channel will disappear.
8. When you have completed your selection, press the CLR key to return to
radio operation.
To check channels to be scanned, press the CH▼/CH▲ key
repeatedly. The “ [MEM]” icon will appear when the memory
channel is displayed.
Note: When “SCAN MEMORY” is assigned to the soft key, the
memory function switches between on and off every time
you press the [MEM] soft key.
P
16
DISTRESS
VOL
118°09.582
33°37.120
W
s
LOC 09.56 AM
BUSY HI USA
TIME
LON
LAT
MEM
P-SET
8.9.3 Memory Scanning (M-SCAN)
1. Set the scan type to “MEMORY” in the SETUP menu (refer to “ 8.9.1 Select-
ing the Scan Type”).
2. Press the SQL key, then press the CH▼/CH▲ key until background noise
disappears.
3. Press the ◄/► key repeatedly, then press the [SCAN]
soft key. “MEM SCAN” appears on the display. Scanning
will proceed from the lowest to the highest programmed
channel number and preset channel (described in the next
section) and will stop on a channel when a transmission is
received.
P
16
MEM
SCAN
VOL
118°09.582
33°37.120
W
s
LOC 09.56 AM
BUSY HI USA
TIME
LON
LAT
MEM
P-SET
The channel number will blink during reception.
4. To stop scanning, press the 16/S or CLR key.