Gasboy Fuel Point Vehicle Module - Manual (Page 41)

MDE-4524A Vehicle Module Programming Manual· May 2006 Page 5-13
Programmer Operating Modes Operation
14 Enter the hour meter reading, including tenths if present. Remember to enter leading zeros as
necessary. If there is no hour meter, just press 0, then ENTER to start the hours counter at
zero.
YES
ENTER
0 0
6
MNO
5
JKL
4
GHI
PRESET TIME [2]
[H] ???4560.0
15 Hold the Programmer near the vehicle's T-Ring.
HOLD PROGRAMMER
NEAR TANK RING
16 When communications is established, a series of beeps will be heard. Continue to hold the
Programmer near the T-Ring. Programming takes about 5 seconds.
TRANSMITTING
PLEASE WAIT
17 When programming is complete, you will hear a long beep.
TRANSMISSION
COMPLETE
18 The Programmer turns off automatically.
Edit Mode
Before continuing, you can use Edit Mode to verify that the data you entered during Program
Mode is correct. This mode will display all VM data except for the counter data. The counter
data is available via Calibrate Mode, which will be explained later.
1 Turn on the Programmer. Refer to “Turning On Programmer” on page 5-1 .
2 Select Edit mode.
YES
ENTER
1 - PROG 2 - EDIT
3 - CAL 4 - DIAG ?
2
ABC