Gasboy Fuel Point Vehicle Module - Manual (Page 38)

Operation Programmer Operating Modes
Page 5-10 MDE-4524A Vehicle Module Programming Manual· May 2006
16 When communications is established, a series of beeps will be heard. Continue to hold the
Programmer near the T-Ring. Programming takes about 15 seconds.
TRANSMITTING
PLEASE WAIT
17 When programming is complete, you will hear a long beep.
TRANSMISSION
COMPLETE
18 The Programmer turns off automatically
Testing the Odometer/Hours Operation
1 Since the odometer ratio was programmed as 1, you only need to back the car up about 10 feet,
then forward again, to make the VM think you drove many miles. Since this particular vehicle
is also recording engine hours, you need to let it idle for at least 6 minutes to get the VM to
increment to the next hour.
DANGER !
To avoid the build-up of deadly carbon-monoxide gas, DO NOT idle the vehicle in an
enclosed area.
2 Turn on the Programmer. Refer to “Turning On Programmer” on page 5-1 .
3 Select Calibrate mode. We are only using Calibrate mode here because we know the odometer
data is incorrect. The sequence presented here does not use Calibrate mode features for
determining the correct ratio and resetting the initial counters. These features are explained
later in the Calibrate Mode section.
YES
ENTER
3
DEF 1 - PROG 2 - EDIT
3 - CAL 4 - DIAG ?