Gasboy Fuel Point Vehicle Module - Manual (Page 11)

MDE-4524A Vehicle Module Programming Manual· May 2006 Page 3-1
Vehicle Module Programmer Component Overview
3 – Component Overview
Vehicle Module Programmer
The Vehicle Module (VM) Programmer is a hand-held, cordless device used to interact with
the Fuel Point System components. It contains an antenna for communicating to the VM
through the vehicle T-Ring antenna. The two-line, alphanumeric display prompts the user
through each step, making it easy to use in the shop, in the fleet yard, at the job site, or at the
fueling island.
Figure 3-1
CHARGER
CHARGER CONNECTOR
CONNECTOR
FACTORY PROGRAMMING
ALPHANUMERIC
KEYPAD
32 CHARCTER
ALPHANUMERIC
DISPLAY
3 9/16
(90.50)
6
1/4
(158.75)
2 1/4
(57.15)
2
3/4
(69.85)
C06736 VM Programmer with Charger
Note: C06736 VM Programmer will be shipped only till end of February 2006. Starting
March 2006, M06728A001 VM Programmer will be shipped.
The Programmer has five operating modes which are explained in detail in “Programmer
Operating Modes” on page 5-7 .
• Program. When initially installing the VM, it allows you to load the vehicle's
identification and fuel control data, similar to encoding data for a card- or key-based Fuel
Management System (FMS). The VM can be re-programmed with new data at any time.
• Edit. This mode allows you to read back data to verify that a VM was programmed
correctly. It can also be used to change partial data in a programmed VM without re-
entering the entire VM data (as in Program mode).