beautypg.com

Mode selection – Gasboy Fuel Point Vehicle Module User Manual

Page 30

background image

Operation

General Programmer Operation

Page 5-2

MDE-4524A Vehicle Module Programming Manual· May 2006

Mode Selection

After the Programmer is turned on, the first menu, showing modes 1 through 4 is displayed.
Within 4 seconds, the second menu, showing mode 5, is displayed. The Programmer toggles
between menus every 4 seconds, or you can manually switch menus by pressing ENTER. To
select a mode, press the mode number followed by ENTER. Selection can be made for any
mode even when the display is not currently showing its associated menu

_

_

_

_

DIAG ?

1 PROG 2 EDIT

3 CAL 4

5 -- VERS

?

1

YES

ENTER

ENTER VM NUMBER:

522748_

Accepting Old Data and Clearing the Display for New Data Entry

The Programmer saves previously entered data for the Program and Edit modes. When
stepping through these modes, that data is displayed for each field so that you can just press
ENTER to keep the data as-is and advance to the next field. If you need to change any data
within a field, you must press the CLR key first, to clear the field for new data entry. Then
press the ENTER key to save the change. In order to avoid repetition throughout this manual,
most subsequent example sequences starts with the field already cleared.

Note: If you make any mistake while typing the data, you can press the CLR key to go back to

the beginning of the current field, then type the correct data.

YES

ENTER

NO

CLR

ENTER VM NUMBER:

5001

ENTER DIVISION:

006442

ENTER LICENSE:

TAM0693

ENTER LICENSE:

???????_