Flowserve SPECTORcontrol User Manual
Spector control
Table of contents
Document Outline
- SPECTORcontrol
- Contents
- Important Notes
- Explanatory Notes
- Installation
- Wiring
- Commissioning
- User Interfaces
- System Menu
- Menus of Inputs/ Outputs
- CAN 1..10 input
- CAN type 1..10
- NRG 26-40 CAN 1...10
- NRG 26-40 setup
- NRG 26-40 calibration
- NRG 16-42 CAN 1...10
- NRG 16-42 setup
- LRG 16-40 CAN 1...10
- LRG 16-40 setup
- LRG 16-40 calibration
- Select standard curve
- Select temperature coefficient
- Current values of control equipment
- NRS 1-40
- NRS 1-41
- NRS 1-40/ 41 setup
- LRR 1-40
- LRR 1-40 setup
- CAN 1..10 output
- Digital inputs
- Digital outputs
- Digital output 1...10 energised
- Analog 1..10 input
- Analog input 1..10
- Analog input 1...10 setup
- Analog 1..10 output
- Analog output 1..10
- Controller Menu
- Controller
- Controller setup
- Continuous controller setup
- Continuous controller
- 2-position controller setup
- Pump setup
- Pump 1...3 setup
- Valve control
- 2-pos. controller
- Pump status
- 3-position controller setup
- 3-pos. controller
- 3-element controller
- 3-element controller setup
- 3-element continuous controller setup
- 3-element 3-position controller setup
- 3-element continuous/3-position controller
- Intermittent blowdown
- Intermittent blowdown setup
- Boiler Menu
- Boiler
- Maintenance
- Maintenance 1...5 setup
- Signal assignment of digital input
- Datalogs
- Datalog 1...5 setup
- Select signal channel 1...2
- Datalog 1...5
- Edit datalog 1...5
- Datalog 1...5 range of representation
- Flowrates
- Flowrate 1...5 setup
- Select signal for flowrate 1...2
- Flowrate 1...5 parameter
- Daily log / monthly log
- Burner Menu
- Burner
- Fuel gas/oil
- Position of actuator
- Common inputs/outputs
- Controller
- Datalogs
- Datalog 1...5 setup
- Select signal channel 1...2
- Datalog 1...5
- Edit datalog 1...5
- Datalog 1...5 range of representation
- Flowrates
- Flowrate 1...5 setup
- Select signal for flowrate 1...2
- Flowrate 1...5 parameter
- Daily log / monthly log
- Malfunction history
- Fault history
- Burner set-up
- Fuel
- Operating hours
- Setpoint
- Start-up counter
- Clock
- Operating mode
- Mode
- Operating mode
- Capacity controller
- Capacity controller
- Targeted capacity specification
- Alarm
- List of Equipment
- Annex