Flowserve SPECTORcontrol - Manual (Page 14)

14
Commissioning
– contin ued –
Remote monitoring
SPECTOR control allows remote monitoring and operation via PC. For this purpose a
browser (Internet Explorer 5.5 or higher) must be installed as frontend. You can also use
a handheld PC.
There are two ways to establish a connection:
1. A direct connection to the network/Intranet can be implemented via the integrated
Ethernet interface using a patch cable (RJ45).
Or, alternatively, the connection can be established via Hub/switch.
2. An analog modem can be connected to the serial interface COM3 (RS232). In this
case the connection will be directly established, e. g. via Internet.
The following device has been tried and tested by GESTRA:
■ devolo-Microlink 56 k Fun II serial
The IP address of SPECTOR control can be obtained from your system or network
administrator. The IP address must be uniquely defined in the network.
Integration of third-party equipment
Third-party equipment such as Profibus and MODBus can - after prior consultation with
GESTRA - be directly connected to SPECTOR
control .
Using the help function
You find the help function of the screen mask in the top right corner of the menu bar.
When you press the button with the question mark a new window will pop up, giving
additional information on the current screen mask. The window is closed by the user.