Smtp server, Smtp port, Authentication required – Contemporary Control Systems BASview User Manual
Page 59: Username, Password, Sender, Test recipient, Ftp/telnet tab, Ftp/telnet password, Ftp port
TD110500-0MC
59
SMTP Server
This is the address of the Simple Mail Transfer Protocol (SMTP) server to use when sending email.
SMTP Port
This is the port number used by the SMTP server.
Authentication Required
Select this option if the SMTP server requires user authentication.
Username
This is the username for the SMTP server authentication.
Password
This is the password for the SMTP server authentication.
Sender
This is email address of the sender of all email. If a user receives email from the BASview and clicks
"Reply" in their email program, this will be the default recipient of the reply.
Test Recipient
To test email settings, type a valid email address then click the "Test" button. If changes are made to the
email settings, they must be applied before sending a test email.
FTP/Telnet Tab
These settings are only for advanced users. Most users will not access the unit via FTP or Telnet.
The DNS setting on the network tab must be correct for FTP and Telnet to function properly.
The unit must be rebooted by selecting "Reboot" from the Admin menu for any changes made
on the FTP/Telnet tab to take effect.
FTP/Telnet Password
The FTP and Telnet server share a single password. Type it here and in the "Password Confirm" box.
FTP Port
This is the port number the FTP server will use.
Telnet Port
This is the port number the Telnet server will use.
NTP Tab
NTP synchronises the BASview web server time with an external time server. It does not modify any
devices. The specified NTP server must be reachable on port 123. This usually requires BASview
access to the Internet. Results of the daily 3 am NTP sync are in the System Log.
NTP Server
This is the full URI of a valid NTP server. A common one is "pool.ntp.org" (without the quotes).
Auto NTP Enabled
Checking this enables automatic NTP synchronisations around 3 a.m. each morning.
Sync Now
After specifying a valid server, click this to test the settings and perform an immediate synchronisation.
(Use at least 6 of these characters:
A
–Z
,
a
–z
,
0
–9
and
!@#$%^&*()_-
)