Configuration commands/responses, A.3 configuration commands/responses – Comtech EF Data SMS-301 User Manual
Page 87
SMS-301 Redundancy Switch
Remote Control Operation
Rev. 3
A-5
A.3 Configuration
Commands/Responses
Operational
Mode
Command:
Response:
Status:
Response:
Where: xxxxxx = AUTO or MANUAL.
This command selects the mode of operation for the SMS301.
Notes:
1. If AUTO is selected, the Monitor and Control in the
SMS301 controls all switching decisions.
2. If MANUAL is selected, the operator controls all
switching decisions via the next 3 following commands.
Set Online
Modulator
(Indepen-
dent
Switching)
Command:
Response:
Status:
Response:
(See Note) >add/MOL_x'cr''lf'] Where: x = A or B (Modulator Online number). This command puts the specified modulator online. Note: Manual Mode Only. Set Online Command: Status: (See Note) >add/DOL_x'cr''lf'] Where: x = A or B (Demodulator Online number). This command puts the specified demodulator online. Note: Manual Mode Only. Set Online Command: Status: (See Note) >add/MOL_x'cr''lf'] Where: x = A or B (Modem Online number). This command puts the specified modem online. Note: Manual Mode Only. Modulator's Command: Status: (See Note) >add/MA_yyy'cr''lf'] Where: yyy = YES or NO. Note: Manual Mode Only. Demod Command: Status: (See Note) >add/DA_yyy'cr''lf'] Where: yyy = YES or NO. Note: Manual Mode Only. Switching Command: Status: (See Note) >add/SM_yyy'cr''lf'] Where: yyy = IND (Independent) or DEP (Dependent). Note: Manual Mode Only. Modem Command: Status: Where: yyy.y = 0.0 to 127.0 seconds (in .5 second Modulator Command: Status: Where: yyy.y = 0.0 to 127.0 seconds (in .5 second
Demod
(Indepen-
dent
Switching)
Response:
Response:
Modem
(Dependent
Switching)
Response:
Response:
Active
(Enable)
Response:
Response:
Active
(Enable)
Response:
Response:
Mode
Selection
Response:
Response:
Online
Delay
(Dependent
Switching)
Response:
Response:
increments).
Online
Delay
(Indepen-
dent
Switching)
Response:
Response:
increments).