Comtech EF Data SMS-301 - Manual (Page 23)

Rev. 3 2–1
2
Chapter 2.
INSTALLATION
This chapter provides installation information for the 1:1 switch, including unpacking,
inspecting the parts, and external connections.
2.1 Unpacking
The 1:1 switch and manual are packaged in pre-formed, reusable cardboard cartons
containing foam spacing for maximum shipping protection. To remove the 1:1 switch,
proceed as follows:
C AU TIO N
Do not use any cutting tool that will extend greater than 1-inch into the
container and cause damage to the 1:1 switch.
1. Cut the tape at the top of the carton where it is indicated OPEN THIS END.
2. Lift out the cardboard/foam spacer covering the 1:1 switch.
3. Remove the 1:1 switch, manual, and power cords from the carton.
4. Save the packing material for reshipment either back to the factory or to another
location.
5. Inspect the equipment for any possible damage incurred during shipment.
6. Check the equipment against the packing list to ensure that the shipment is
complete.
7. Refer to Section 2.2 for further system installation instructions.