Comtech EF Data DMD-2050E - Manual (Page 219)

DMD2050E Universal Satellite Modem Carrier Control
MN-DMD2050E Revision 2 C–3
2. The output starts again automatically.
C.3.4 Carrier VSAT
The carrier state is Carrier VSAT.
You change the modulator output and the satellite footprint.
If you use the front panel to make the change:
1. The output is stopped automatically.
2. A popup message prompts you to confirm the change.
3. The unit waits for signal lock to occur on the demodulator.
4. The output starts again automatically.
If you use a terminal to make the change:
1. The output is stopped automatically.
2. You restart the output.
C.3.5 CARRIER RTS
The carrier state is Carrier RTS.
You change the modulator output and the satellite footprint.
If you use the front panel to make the change:
1. The output is stopped automatically.
2. A popup message prompts you to confirm the change.
3. The unit checks the Request to Send (RTS) status.
4. If RTS is ON, the output starts again automatically.
5. If RTS is OFF, the output does not start.
If you use a terminal to make the change:
1. The output is stopped automatically.
2. You restart the output.