8 remote aupc (menu), 9 ita (menu) – Comtech EF Data DMD-2050E User Manual

Page 125

DMD2050E Universal Satellite Modem

User Interfaces

MN-DMD2050E Revision 2

4–13

4.4.1.8

REMOTE AUPC (menu)

NOTE
Remote AUPC Menus are available only when the modem is configured for EF AUPC.

REMOTE AUPC MENU
AUPC MODE

{DISABLE,NEAR SIDE,
EFDATA}

Enable or disable the AUPC Function of the remote modem. The
remote AUPC Function is the response of the local modem to
commands for an increase or decrease of the Transmit Power in
0.5 dB steps and the command to change to the setting indicated
in the 'REMOTE CL ACTION' Menu of the remote modem upon
receiver loss of lock.

LOOPBACK

{DISABLE, ENABLE}

Enable or disable the Baseband Loopback Test Mode of the
remote modem.

TX 2047 TEST {DISABLE, ENABLE}

Enable or disable the Transmit 2047 Pattern Test Mode of the
remote modem.

RX 2047 BER:

Reports the BER measurement of the receiver 2047 Pattern Test
Mode of the remote modem. BER is reported from the 1x10

-5

1x10

-7

in tenth decade steps. If the pattern does not synchronize

or is out of range, ‘NO DATA’ is displayed.

4.4.1.9

ITA (menu)

IMPORTANT
When the EBEM Network Specification is selected these parameters are available.

ITA Option

{DISABLED, ENABLED}

Enable or disable the ITA
Function.

BPSK 1/2

{NOT SELECTED, SELECTED}