Comtech EF Data DMD-2050E - Manual (Page 145)

DMD2050E Universal Satellite Modem User Interfaces
MN-DMD2050E Revision 2 4–33
4.4.6.9 TRANSEC (menu)
TRANSEC MENU
IP ADDR MASK
{XXX.XXX.XXX.XXX} The IP Address Mask of the TRANSEC Module. The mask is
expressed in a hexadecimal format, and must be a valid TCP/IP Mask.
This field should be set before changes are made to the Modem or
Router Address.
MODEM IP ADDR {XXX.XXX.XXX.XXX} The IP Address of the TRANSEC Module. This address should be
consistent for the mask defined. This address is expressed in
hexadecimal format. Broadcast and loop back addresses will not be
allowed. These are addresses with all subnet bits set to 0’s or 1’s.
ROUTER IP ADDR {XXX.XXX.XXX.XXX} The IP Address of the Router. If a router is present on the local
network, this address must be consistent with the IP Mask and the
subnet of the modem. If no router is present, then the address should
be set to a foreign address. This address is expressed in hexadecimal
format. Broadcast and loop back addresses will not be allowed.
These are addresses with all subnet bits set to 0’s or 1’s.
4.4.6.10 HW/FW CONFIG (menu)
FIRMWARE REV Displays the firmware part number and revision.
M&C REV Displays the installed Monitor and Control revision.